-
CVE-2026-93077
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
cxl/features: Clamp Get Feature output size to the remaining buffer
cxl_get_feature() reads a feature in a loop but passes a fixed size_out
as the output capacity every iteration. On the last partial iteration
the buffer has less room left, so a device that returns more than asked
can overflow feat_out.
Use the per-iter size data_to_rd_size, which already tracks the
remaining room, as the output capacity.
-
CVE-2026-93076
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
dax/fsdev: clear vmemmap_shift when binding static pgmap
Clear pgmap-vmemmap_shift for static DAX devices. When rebinding a static
device from device_dax (which may set vmemmap_shift based on alignment) to
fsdev_dax, the stale vmemmap_shift persists on the shared pgmap. Explicitly
zero it before devm_memremap_pages() so the vmemmap is built for order-0
folios as fsdev requires.
-
CVE-2026-93073
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
dax: read holder_ops once in dax_holder_notify_failure()
dax_holder_notify_failure() reads dax_dev-holder_ops twice without
READ_ONCE() -- once for the NULL check and once for the indirect
notify_failure() call. A concurrent fs_put_dax() can clear holder_ops
between the two reads, so the check can observe a non-NULL pointer while
the call dereferences NULL. (kill_dax() also clears holder_ops, but only
after synchronize_srcu(), so it cannot race a reader that is inside
dax_read_lock(); fs_put_dax() does no such synchronization.)
Fetch holder_ops once into a local with READ_ONCE() so the NULL check and
the indirect call observe the same value.
-
CVE-2026-93071
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
media: bcm2835-unicam: Fix asc leaked in error/remove path
v4l2_async_nf_add_fwnode_remote() allocates the asc, which is freed when
v4l2_async_nf_cleanup() is called.
Call v4l2_async_nf_cleanup() properly in the driver paths.
Discovered with kmemleak after rmmod:
unreferenced object 0xffff000084526b80 (size 64):
comm "modprobe", pid 185, jiffies 4295013512
hex dump (first 32 bytes):
01 00 00 00 00 00 00 00 e8 0d ff bf 00 00 ff ff ................
40 83 bc 84 00 00 ff ff 60 83 bc 84 00 00 ff ff @.......`.......
backtrace (crc ac584083):
[00000000ffb081a7] kmemleak_alloc+0x38/0x44
[<00000000d2fd9301>] __kmalloc+0x1b0/0x250
[<000000004dd5354d>] __v4l2_async_nf_add_fwnode+0x28/0x9c
[<0000000067587657>] __v4l2_async_nf_add_fwnode_remote+0x3c/0x64
-
CVE-2026-93070
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
media: ipu6: Do not free aux device pdata after init
ipu6_bus_initialize_device() stores the isys/psys pdata pointer in
struct ipu6_bus_device and initializes the auxiliary device. After that
point, error unwinding must drop the auxiliary device reference and let
ipu6_bus_release() free both the bus device and adev-pdata.
The isys and psys init paths already call put_device() when MMU
initialization fails, and ipu6_bus_add_device() calls
auxiliary_device_uninit() on auxiliary_device_add() failure. Both paths
therefore run the bus release callback. The extra kfree(pdata) in the
callers can release the same object a second time.
Remove the manual pdata frees after the auxiliary device has been
initialized.
This issue was found by a static analysis checker and confirmed by
manual source review.
-
CVE-2026-93065
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: fix counter type in iwl_fwrt_dump_error_logs
The loop counter 'count' was declared as u8 while num_pc is u32.
If firmware advertises more than 255 PC entries the counter wraps
back to zero and the loop never terminates potentially causing an
infinite loop or reading past the allocated pc_data array.
Change the declaration to u32 to match num_pc.
-
CVE-2026-93063
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mei: check SAP message length before reading it
Verify the SAP message size is not larger than the local buffer before
reading the message to avoid buffer overflow.
-
CVE-2026-93062
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: guard against division by zero in iwl_dbg_tlv_alloc_fragments
Make sure we don't end-up with a num_frags = 0 situation.
For that, check that the required size is not 0 and put a checker on
num_frags as well.
-
CVE-2026-93056
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_uac1_legacy: remove broken string configfs attributes
The UAC1_STR_ATTRIBUTE macro defines configfs show/store handlers for
the fn_play, fn_cap, and fn_cntl string options. The store function
contains an inverted null check on the kstrndup() return value.
This means every write attempt returns -ENOMEM on success and
dereferences a NULL pointer on allocation failure. The attributes
have been broken and unused for many years.
Remove the UAC1_STR_ATTRIBUTE macro and the three attributes it
generated. The internal defaults (FILE_PCM_PLAYBACK, FILE_PCM_CAPTURE,
FILE_CONTROL) set in f_audio_alloc_inst() are unaffected.
-
CVE-2026-93050
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
ipack: ipoctal: fix UAF, null-ptr-deref, and use-after-free in cleanup on remove
Three issues arise when the device is removed while a tty session is
still active:
1. UAF of struct ipoctal: the remove callback frees ipoctal via
kfree() while tty ops may still access it. Fix by introducing
kref-based lifetime management — kref is taken in install() when
a tty is opened and released in cleanup() when the tty is finally
destroyed; remove() uses kref_put() instead of kfree().
2. NULL dereference in ipoctal_write_tty(): __ipoctal_remove()
frees xmit_buf via tty_port_free_xmit_buf() while a userspace
process may still hold the tty fd and call write(). Fix by
checking for NULL xmit_buf in ipoctal_write_tty().
3. UAF in ipoctal_cleanup(): ipack_put_carrier(ipoctal-dev)
dereferences ipoctal->dev after the ipack_device has been freed
by ipack_device_del(). Fix by caching ipoctal->carrier_owner
during probe() and calling module_put() on the cached pointer
directly in cleanup(), avoiding any access to ipoctal->dev.
Also introduce a "removed" flag in struct ipoctal, set at the start
of __ipoctal_remove(), and checked in every tty op that accesses
hardware resources (port_activate, write_tty, set_termios, hangup,
shutdown). This prevents page faults when devm_ioremap() regions
are unmapped after remove() returns.
-
CVE-2026-93041
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: dw-edma: Serialize abort state updates
dw_edma_abort_interrupt() drops vc.lock before changing request and
status. issue_pending() can acquire the lock in that small window,
observe the old busy state, and skip starting queued descriptors. Then
the abort handler overwrites the channel status as idle, leaving the new
descriptors stranded for good.
Keep descriptor completion and the state transition in the same critical
section.
-
CVE-2026-93039
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
ASoC: meson: Keep link pointers valid on realloc failure
meson_card_reallocate_links() grows the DAI link and private data
arrays with two consecutive krealloc() calls and updates the owner
pointers only after both calls have succeeded.
A successful krealloc() may move the data: it frees the old block and
returns a new one. When that happens for the link array and the second
krealloc() then fails, card-dai_link still points to the block that
krealloc() already freed, and the error path frees the new block too.
The probe error path then calls meson_card_clean_references(), which
dereferences card->dai_link and kfree()s it again, resulting in a
use-after-free and a double free.
Commit card->dai_link and card->num_links right after the first
krealloc() succeeds, so the pointer always refers to a valid allocation
that meson_card_clean_references() can walk and free. krealloc() with
__GFP_ZERO zero-initializes the added entries, so walking them on the
error path is safe. With both failure paths reduced to a plain return,
drop the goto labels and the error message.
-
CVE-2026-93038
•
published on September 17, 2026
In the Linux kernel, the following vulnerability has been resolved:
iio: dac: ad5686: missing NULL check on match data
Verify that chip_info pointer is not NULL. If a user binds the driver
using driver_override via sysfs with a device name not present in the
id_table or of_match_table, match data will be NULL.
-
CVE-2026-93034
•
published on October 8, 2026
SGLang contains an arbitrary code execution vulnerability caused by the ZMQ message decoder unconditionally deserializing PickleWrapper payloads via pickle.loads() in _maybe_unwrap_pickle without type allowlisting or authentication; this vulnerability persists via the msgpack path even when SGLANG_USE_PICKLE_IPC is disabled, and becomes remotely exploitable if data-parallel attention is enabled with a non-loopback --dist-init-addr setting.
-
CVE-2026-93031
•
published on September 18, 2026
The WP Cloud Plugins Use-your-Drive, Out-of-the-Box, Share-one-Drive, and Lets-Box plugins for WordPress are vulnerable to Arbitrary File Upload in all versions from 2.0 up to, and including, 3.8.3 via the download_file_to_uploads function. This is due to the import action being registered for unauthenticated users via wp_ajax_nopriv_, a missing capability check in can_import(), and the imported file's extension and contents not being validated against get_allowed_mime_types() before it is written to the uploads directory. This makes it possible for authenticated attackers, with subscriber-level access and above, to upload files that may be executable, which makes remote code execution possible.
-
CVE-2026-93030
•
published on September 25, 2026
FTM 4.x ALL could allow a remote authenticated attacker to obtain sensitive information due to an XML external entity injection flaw.
-
CVE-2026-93019
•
published on September 18, 2026
Imager versions before 1.036 for Perl exit the process reading a TGA with a colour map length of 32768 or more in tga_palette_read.
The reader unpacks the two-byte colour map length into a signed short, so a length of 32768 or more becomes negative. tga_palette_read() casts that value to size_t and asks mymalloc() for a size near SIZE_MAX. The allocation fails and Imager's allocator calls exit(3).
Reading an attacker-supplied file through Imager-read() triggers an uncatchable exit.
-
CVE-2026-93009
•
published on October 29, 2026
A flaw was found in dnsmasq. The DHCPv6 client hostname parser can read one byte past the end of a crafted FQDN option because it checks the next label length before confirming the pointer is still inside the option. An attacker on the local network can trigger this with a single DHCPv6 packet. The extra byte is not returned to the client or logged, and no crash has been demonstrated.
-
CVE-2026-93006
•
published on October 29, 2026
A flaw was found in dnsmasq. The TFTP server can serve the wrong file contents because a recently used transfer cache is not invalidated when a transfer finishes. An attacker on the local network who can request a TFTP file may cause a later client to receive previously cached data instead of the requested file. In PXE network-boot environments this can substitute attacker-chosen boot content for a victim machine.
-
CVE-2026-93000
•
published on September 28, 2026
The SPS-Suite WordPress plugin through 1.4.0 does not sanitise the search query before using it in a SQL query when its static-page search feature is enabled, allowing unauthenticated attackers to perform SQL injection attacks.